*RETENSTAT,FILE=Filename

Data format:

Three lines with the following parameters:

IGR INODE Kp Td Ti Lmin Lmax
DLLFileName
DLLProcName

Status :

Optional

Purpose :

To adjust the length of a mooring line in order to achieve a specified target tension

Restrictions :

A mooring line must have been created.

Details :

Parameter	Description
filename.dat	File where the tensioning scenario is specified. Two columns: Step and tension. Specify negative tension (for example -1), to indicate steps where the retensioner is OFF.
IGR	The group of elements for which the length has to be adjusted
INODE	The node at which the tension is to be computed, preferably corresponding to one end of the mooring line. If 0, compute the average tension in the group of elements IGR
T0	The target tension, in N, dummy if specified in a file
Kp	Gain of the PID controller, in m/N
Td	Derivative of the PID controller
Ti	Integral of the PID controller
Lmin	Minimum allowable line length
Lmax	Optional : Maximum allowable line length
DLLFileName	DLL file name
DLLProcName	DLL procedure name